Lamps frontal Opalo 3 Stoots

Description:




Ease of use:

A double click at startup is used to unlock our lamps, then a short click increases the power and a long click decreases it.



When starting from an off lamp, a long click allows you to check the battery level through red flashes, then access the hidden modes, as shown in the diagram below:

Lighting performance and characteristics of Stoots headlamps from the OUTDOOR range:



Accessories available:

• Batterie easyLock 18
• Chargeur easyLock 18
• Support smartpad easyLock 18
• Support flexpad easyLock 18
• easyLock 18 stick-on helmet holder
• Support smarpad max easyLock 18
• easyLock 18 bicycle helmet holder
• Support Gopro easyLock 18
• EasyLock 18 bike handlebar tube holder
• easyLock 18 bike holder
• Color palettes for the front panel (white, yellow, green, orange, blue, purple)

Technologies:

- Mixing Focus

Mixing Focus is an electronic focusing technology specially developed by Stoots.

This technology allows the width of the beam to be adjusted depending on the lighting mode.
With conventional lighting, the lighting angle of which is constant, when we increase the light intensity, we also increase the width of the illuminated area, to the detriment of the lighting range of the headlamp.

Mixing Focus technology modifies the beam angle depending on the lighting powers. The brighter you shine, the narrower the cone of illumination.
By setting this optimally, we maintain very comfortable lighting (well diffused and bright near vision) while considerably increasing the range of the beam.


- Fashion SPOT

The ultra-focused SPOT beam allows you to point to a specific area.
Stoots developed this lighting to allow users to fix a precise point, the SPOT passes through the diffuse lighting of other lamps thanks to its very narrow angle.

- the LEDs

Depending on these different parameters, Stoots chooses the LEDs in its lamps in order to optimize performance while primarily providing pleasant lighting. All our lamps have 4000 K LEDs with a CRI of 80, offering you lighting with the most natural rendering possible.

For diffused lighting, Stoots uses different LEDs (wide, medium, narrow) which have around 240 lumens/W.

The spot is based on a 150 lumens/W LED.  For this beam, a minimum size of the LED is preferred rather than seeking to maximize its pure power. We thus obtain a very narrow and very clear beam with a greater range than if we had selected an LED with better efficiency but a larger emitting source.

Thanks to these technological choices, Stoots lamps combine comfortable lighting with a light output that can be up to 2x higher than other headlamps in the same category. This explains the excellent weight/power ratio of Stoots lamps. With better efficiency, the battery can be smaller for the same autonomy.


- regulated electronics

The regulated electronics prevent a drop in brightness by maintaining a constant supply voltage for the LEDs, regardless of the battery charge level.
So, for example, a lamp advertised at 200 lumens will be able to provide these 200 lumens throughout its operating cycle.

In practice, a good number of regulated lamps are only partially regulated.
Regulation is active on the first half of the battery, then unregulated on the second half. This is linked to the type of electronics used which does not allow regulation over the entire range of use of the battery.



Stoots lamps feature cutting-edge electronics based on switching architectures.

These PWM (Pulse With Modulation) regulated electronics provide high efficiency (92%) over their entire operating range.
Autonomy is maximized, weight and battery size are limited.
The microcontroller continuously measures the battery's state of charge to provide low-battery alerts during use.
It also controls the lamp from the control button. Finally, all of the electronics have been optimized in terms of size to offer maximum functions and power in very small boxes.

The easyLock concept




Charge your lamp




Operation of the ignition paddle




Battery test and hidden mode




Installing a Top Strap




Replacing the switch paddle




Mounting the strap in the support 




Adjust the hardness of the media