Whizzz Acrylic Tape Colltex

Experimental protocol:

1) You need:
- Whizzz acrylic strips
- scissors
- a cutter
- adhesive tape to hold the tape in place
- a large and flat work surface

2) Preparation:
Remove dust, dirt, pine needles, gravel from the sticky side of the skin.

3) Unroll the Whizzz strip, protective film down, on a clean work surface resistant to cutter blows.
Unroll a strip the length of the skin and secure it at both ends with tape.

4) Lay the skin, sticky side down, as straight as possible on the Whizzz strip and press firmly along the entire length.

5) Cut the Whizzz strip along the skin.

6) Turn the skin over, sticky side up, and carefully cut the protection under the stirrup and the rear clip.
Press the protective film again over the entire length of the skin.

7) Store the skins in the bag provided for this purpose.

8) Leave the plastic protection on until the next use of the skin.